top of page

Aircon Not Blowing Air at All?

  • thesnowflakesg
  • Sep 9, 2023
  • 2 min read

Updated: 59 minutes ago

If your aircon turns on but doesn’t push out any air — or stops blowing midway — you’re not just losing cooling. You’re losing control over the system’s core function. It’s often tied to fan faults, airflow blockages, or component failure.


What Causes an Aircon to Stop Blowing Air?

1. Fan motor failure

If the fan motor is burnt, jammed, or electrically disconnected, no air will move — even if the system powers on.


2. Blower wheel is stuck or damaged

Dust or debris can lock the wheel in place. In some cases, the wheel may detach, spin freely, or not engage with the motor.


3. Frozen coil

If the coil ices over due to poor airflow or low gas, the air can’t pass through. Fan might still be trying — but you’ll feel nothing.


4. Capacitor issue

A weak or failed capacitor won’t start the fan motor — common in older units or after a power surge.


5. Thermostat miscommunication

If the control board isn’t receiving or sending the correct signals, the fan may never activate — even with correct settings.


6. Power or circuit issue

A tripped breaker or partial power loss may stop only the fan components, while lights or remote functions still work.


7. Filters completely blocked

In severe cases, clogged filters can reduce airflow so dramatically that you feel almost nothing — especially in small rooms.


8. Vent or ducting issues

In ceiling or ducted units, disconnected ducting or blocked vents can make it seem like the system isn’t blowing — even if the fan

is running.


What You Can Check First

  • Do you hear the fan trying to spin?

  • Filters cleaned recently?

  • Any airflow — even weak — from the vents?

  • Coil or pipe frosty?


If it’s completely silent or blowing nothing — shut it down and book a check. Continuing to run it may burn the motor or fan module.


Why It Matters

No airflow = no cooling. And if left unresolved:

  • The compressor can overheat

  • Fan components may fail permanently

  • Frost buildup can flood the tray

  • PCB or motor replacement costs can rise


Zero airflow is a full stop — not a minor slowdown.


When to Book a Diagnostic

✅ System powers on, but no air comes out

✅ Fan is silent or makes odd clicking/buzzing sounds

✅ Airflow cut out mid-use and hasn’t returned

✅ Already cleaned filters but no change


We’ll test the motor, fan circuit, blower wheel, and internal airflow pathways to pinpoint the fault — and fix it properly.

© 2025 Snowflake Aircon Services. All rights reserved.

bottom of page